Text For Citation: 01 Item/Group: 002 Hazard:

29 CFR 1910.147(d): Application of control. The established procedures for the application of energy control (the lockout or tagout procedures) shall cover the following elements and actions and shall be done in the following sequence: (1)... (2) Machine or equipment shutdown. The machine or equipment shall be turned off or shut down using the procedures established for the machine or equipment. An orderly shutdown must be utilized to avoid any additional or increased hazard(s) to employees as a result of the equipment stoppage. (3) Machine or equipment isolation. All energy isolating devices that are needed to control the energy to the machine or equipment shall be physically located and operated in such a manner as to isolate the machine or equipment from the energy source(s). (4)(ii) Lockout or tagout device application. Lockout devices, where used, shall be affixed in a manner to that will hold the energy isolating devices in a "safe" or "off" position (5)(i) Stored energy. Following the application of lockout or tagout devices to energy isolating devices, all potentially hazardous stored or residual energy shall be relieved, disconnected, restrained, and otherwise rendered safe. a) On or about May 24, 2021, employees were performing setup, on and around the SANO winding unit number 5 powered by electrical and pneumatic energy. The employer did not ensure sequences (2) through (5) were followed to ensure that employees were not exposed to rotating and moving parts during the "threading" of the winding machine.